| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Engine Mechanical | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000000SME00JX |
| Title: 2UZ-FE ENGINE MECHANICAL: CYLINDER BLOCK: REPLACEMENT (2008 Sequoia) | ||
REPLACEMENT
1. REPLACE RING PIN
NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.
(a) Remove the ring pin.
(b) Using a plastic-faced hammer, tap in new ring pins until they stop.
Standard Protrusion:
|
Ring Pin |
Specified Condition |
|---|---|
|
A |
3.5 to 4.5 mm (0.138 to 0.177 in.) |
|
B |
6.5 to 7.5 mm (0.256 to 0.295 in.) |
|
C |
9.0 to 10.0 mm (0.354 to 0.394 in.) |
2. REPLACE STRAIGHT PIN
NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.
(a) Remove the straight pin.
(b) Using a plastic-faced hammer, tap in new straight pins until they stop.
Standard Protrusion:
|
Straight Pin |
Specified Condition |
|---|---|
|
A |
3.5 to 4.5 mm (0.138 to 0.177 in.) |
|
B |
6.5 to 7.5 mm (0.256 to 0.295 in.) |
3. REPLACE CYLINDER BLOCK TIGHT PLUG
NOTICE:
If water leaks from the tight plug or the plug corrodes, replace it.
(a) Remove the tight plugs.
|
(b) Apply adhesive to the holes' inner circumference where the tight plugs contact. Adhesive: Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
(c) Using SST and a hammer, tap in new tight plugs as shown in the illustration.
SST: 09950-60010
09951-00340
SST: 09950-70010
09951-07100
|
|